How to Fix Low Noise Floor for ACX in Audacity

Someone recently commented on one of my previous videos asking how to fix low noise floor in a project for ACX audiobooks. While the noise floor needs to be less than -60dB to meet ACX requirements, there cannot be silence in your recording. In this video I show you one way to raise your noise floor if it’s too low to meet ACX standards using Audacity.


Do you like what’s going on here? Buy Me A Coffee: https://www.buymeacoffee.com/learnaudacity

Hardware I Recommend (NOTE: As an Amazon Associate I earn from qualifying Amazon purchases).

Software I Use:

How to Trim a Waveform for ACX Using the Selection Toolbar in Audacity

In this video I show you how to trim the precise length of room tone that is required by ACX at both the beginning of your recorded waveform and at the end, using the Selection toolbar in Audacity. ACX requires 0.5 to 1 second of room tone at the beginning of your recorded chapter and 1-5 seconds at the end of each chapter. Using the selection toolbar to trim the excess audio gives you a precise way to be consistent with your recordings from chapter-to-chapter while meeting the ACX standard.

Hardware I used in this video (NOTE: As an Amazon Associate I earn from qualifying Amazon purchases)

Software I Used:

Other places you’ll find me: